Tools Required; Measurement And Marking - Petsafe Staywell 900 Série Guide D'installation

Before installing your cat fl ap
please read the following step-by-
step instructions carefully.

Tools required

• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• 5 mm ( / ") drill bit
3
16
• Screwdriver
• Tape measure
• Sand paper

Measurement and marking

Measure the belly height of your cat. This is usually 100 mm to150 mm (Fig. 1).
Mark this measurement on the outside of your door and draw a straight
horizontal line 169 mm (Fig. 2).
Please bear in mind that this line will eventually be the bottom of the
hole you will cut in your door and that the frame of the cat fl ap will be
slightly lower. If necessary, this line may have to be raised slightly to
account for this.
4
FIG.1
Cutting a hole for your cat fl ap
a) In Wood and PVC/uPVC/Metal
The cat fl ap requires a square cut-out of
169 mm x 169 mm (Fig. 3).
FIG.3
Not to scale - for best results you should
refer to the enclosed cutting template.
www.petsafe.net
FIG.2
(x)
(x)
169 mm
169 mm
Wooden doors
PVC/uPVC/Metal