Melitta CAFFEO Solo & Milk Guide D'utilisation page 78

→ Water will fl ow intermittently out of the steam pipe into the coffee grounds
container. The symbol for the valve
process lasts approximately 10 minutes. Subsequently, the symbol for the
drip tray
10 Leave the valve open.
11 Empty the coffee grounds container and the drip tray and then reinsert
the drip tray. Place the coffee grounds container back under the steam
pipe.
→ The symbol for the water tank
12 Thoroughly rinse the water tank, fi ll it to the max. mark with fresh tap
water and reinsert it.
13 Press the button for steam dispensing
integrated descaling programme.
→ Water fl ows out of the steam pipe into the coffee grounds container. The
symbol for the valve
illuminates.
→ Phase 2 is completed.
Phase 3
During Phase 3, three bean symbols
14 Turn the valve switch anti-clockwise to the stop to close the valve.
→ Water fl ows inside the appliance into the drip tray. Subsequently, the symbol
for the drip tray
15 Empty the drip tray and the coffee grounds container and then reinsert
them.
→ The standby symbol
The appliance is ready for operation.
16 Reinsert the Melitta
76
illuminates.
fl ashes during this process. Then the valve symbol
illuminates.
illuminates after a brief heat-up phase.
Claris water fi lter into the water tank.
® ®
fl ashes during this process. This
illuminates.
to continue with the
are shown on the display.