Setting The Cutting Depth; Vacuum Extraction Of Dust / Debris; Parking Shoe; The Planing Process - Parkside PEH 30 A1 Instructions D'utilisation Et Consignes De Sécurité

Preparing for use
Switching off:
R elease the ON / OFF switch
Note: For safety reasons the ON / OFF switch
cannot be locked in the ON position.

Setting the cutting depth

Q
The rotary control can be used to set the cutting
13
depth in steps from 0–3.0 mm according to the cut-
ting depth scale .
14
Vacuum extraction of dust /
Q
debris (see Fig. A)
DANGER OF INJURY!
Before you carry out any work on the device always
pull the mains plug out of the mains socket.
Planing debris removal port (right / left
selectable):
R elease the planing debris removal port
turning it against the direction of the arrow (out
of the "Lock" position).
P ull the planing debris removal port
the device.
T he planing debris removal port
to face left or right in the planer.
P ush the planing debris removal port
the device.
L ock the planing debris removal port
turning it into the "Lock" position.
External vacuum extraction:
If necessary fit the reducer piece
a dust extraction system, e.g. a workshop dust
extraction system.
The vacuum cleaner / dust extraction device used
must be suitable for the material being planed.
Connection:
P lace the reducer piece
planing debris removal port
P ush the hose of a suitable dust extraction device
approved for that purpose (e.g. a workshop
30 GB
.
2
2
by
3
out of
3
can be set
3
into
3
by
3
when using
15
firmly on to the
15
.
3
vacuum cleaner) on to the planing debris remov-
al port or the reducer piece
3
Removal:
P ull the hose of the dust extraction device off
the planing debris removal port
reducer piece .
15
P ull off the reducer piece
Parking shoe (see Figs. B / C)
Q
The parking shoe allows you to lay the device
16
down without the risk of damaging the workpiece.
When planing, the parking shoe
exposes the rear part of the sole

The planing process

Q
C AUTION! DANGER OF KICKBACK!
Always switch on the device before placing it
against the workpiece.
S et the required cutting depth.
S witch on the device.
A lways place the front part of the sole
first on to the workpiece.
G uide the device with even forward movement
over the surface being planed.
M ove the device forward at a slow rate and
ensure that the contact pressure acts evenly on
the sole . Moving forward at too great a rate
9
results in a poorer surface quality and can lead
to blocking of the planing debris removal port.
Chamfering edges (see Fig. H)
Q
The V-grooves in the front sole
10
to be used for simple chamfering of workpiece edges.
U se the V-groove most appropriate to your
desired chamfer width.
P lace the planer with the V-groove
piece edge and guide the planer along the edge.
.
15
or off the
3
, if fitted.
15
swings up and
16
.
9
down
9
allow the device
9
on the work-
10