Readjust The Milling Depth; Set The Milling Depth With The Step Stop; Milling Direction; Milling Process - Parkside POF 1200 A1 Traduction Du Mode D'emploi D'origine

5. Loosen the clamping lever
wise and pushing the device down until the route
bit touches the surface of the work-piece.
6. Lock the clamping lever in place
it anti-clockwise.
7. Push the depth stop
the lowest position of the step stop
the index indicator
the dial milling depth adjustment
8. Adjust the depth stop
tighten the lock screw
indicator should no longer be adjustable.
13
9. Loosen the clamping lever
device back up.

Readjust the milling depth

The milling depth can be adjusted with the con-
trol dial .
15
Loosen the clamping lever
clockwise and pushing the device down until
the depth stop touches the step stop
12
Lock the clamping lever in place
it anti-clockwise.
Set the milling depth with the control dial
Loosen the clamping lever
wise and lead the device back up. Check the
milling depth through a further practical test.
Set the milling depth
with the step stop
You can use the step stop
several steps with less takeoff.
Set the desired milling depth with the lowest
step of the step stop
Then set it at higher level for the first attempt.

Milling direction

The milling process must always go against the
rotationary direction on the router bit
rotation).
ATTENTION: When milling in the direction of the rout-
er bit (counter rotation) the device fly out of your hand.
by turning it clock-
16
by turning
16
down until it reaches
12
. Move
9
to the position "0" on
13
.
14
to the desired depth,
12
. Afterwards the index
11
and and lead the
16
by turning it
16
9
by turning
16
15
by turning it clock-
16
with deeper depths in
9
(as described above).
9
(Counter
17
.

Milling process

.
Set the milling depth as previously described.
Place the device on the desired work-piece and
switch it on.
Loosen the clamping lever
wise and pushing the device down until it touches
the surface of the depth stop
stop .
9
Lock the device into place by turning the clamp
lever anti-clockwise.
16
Mill with even speed and even pressure (see fig. I).

Set the copy casing

Set the copy casing
ing bar .
8
Secure the copy casing
of the extractor adapter on the base plate
22
Ensure that the copy casing
way round - the thrust ring
down (see fig. D).
Operation
by turning it clock-
16
on the step
12
from below on the slid-
26
with the two screws
26
is set the right
26
must be pointing
25
GB
.
7
43