Moog D791 Série Manuel De L'utilisateur page 4

• Cross-torque screws to:
Type Series
Pilot valve D761
• After start-up, check valve for external leakage.
Replacing O rings: The mounting surface O rings may be re-
placed by the customer (on the pilot valves and the way valves
as well). Pay attention to cleanliness of the valve and of the
surroundings.
Transportation/storage: Before transportation, seal the base
of the valve using a clean shipping plate or adhesive tape.
Seal the connector using a dust protection cap. Pack the valve
carefully so that it is not damaged during transportation or stor-
age.
Inspection: Following a period of storage or no operation for
more than 5 years, we recommend that the valve is inspected
by an authorized service center, in order to prevent possible
damage.
Repairs: Repairs may only be carried out by us or by our au-
thorized service centers.
9 Disposal
It is essential to comply with the relevant national waste dis-
posal regulations and environmental protection provisions
when disposing of valves, spare parts or accessories, packag-
ing that is no longer needed, hydraulic fluid or auxiliary materi-
als and substances used for cleaning!
Mounting and Installation Notes D791/2 (B97072-791-001; Version G, 02/15)
Torque
Screw [Nm] (lbf in)
M4 x 8–12.9 4.07 (36.0)
Page 3/3