Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Selecting the installation loca-
tion
The unit is designed for horizontal
installation on a base in outdoor
areas. The installation site must be
level, flat and firm. The unit should
also be secured to prevent it from
tipping over.
For external installation, please ob-
serve the following instructions to
protect the unit from the influence
of the weather.
It is also possible to install the
unit in the interior of the build-
ing. However, in this case the
circulation of the required air flow
volume (see technical data) must
be assured. Any change to the air
flow volume can result in faults or
damage to the unit.
Rain
The unit should be at least 10 cm
off the ground when mounted on
the roof or ground.
Snow
The unit should be wall-mounted
in areas of heavy snowfall.
Installation should be at least 20
cm above the expected level of
snow to prevent snow from enter-
ing the outdoor unit (Figure 2).
60/44 - K410061801001-00 / 07.2020 -
Sun
The finned condenser gives off
heat in cooling mode.
Exposure to sunlight further in-
creases the temperature of the fins
and reduces the heat released by
the finned heat exchanger.
The unit should, whenever pos-
sible, be installed on the north side
of the building.
If necessary, take measures to pro-
vide sufficient shade (responsibility
of customer).
This could take the form of a small
roof.
However, the discharging warm air
flow must not be affected by the
measures.
Wind
If the unit is being installed in
windy areas, ensure that the warm
outlet air is discharged in the pre-
vailing wind direction. If this is not
possible, it may be necessary to
install a windbreak on-site (Figure
3).
Ensure that the windbreak does
not adversely affect the air intake
to the unit.
4
Installation inside buildings (cooling mode)
Warm air
Air shaft
© www.kemper-olpe.de
Note!
Cooling capacity changes as a
consequence of ambient con-
ditions influenced by rain, sun,
wind, and snow, for example.
2
Minimum clearance to snow
Snow
3
Windbreak
Wind
Additional
fan
Warm air
Chiller
20 cm
Cold fresh
air
Air shaft
Publicité
Chapitres
Table des Matières
