Safety Notes; Environmental Protection And Recycling; Disposal Of Packaging; Liability - Kemper KHS CoolFlow 618 01 001 Manuel D'utilisation

Safety notes

Carefully read the operating manu-
al before placing the unit in service
for the first time. It contains useful
tips and notes as well as hazard
warnings to prevent injury to perso-
ns or material damage
Failure to follow the directions in
this manual can endanger persons,
the environment and the equip-
ment itself and will void any claims
for liability.
Keep this manual and the refri-
■
gerant data sheet near the unit.
Only qualified personnel may
■
set up and install the units and
components.
The unit and its components
■
must be set-up, connected and
operated in accordance with the
use and operating conditions
stipulated in this manual and
comply with all applicable local
regulations.
Stationary units must be perma-
■
nently installed for operation.
Modification of the units and
■
components supplied by KEM-
PER is not permitted and can
cause malfunctions.
Units and components may
■
not be operated in areas where
there is an increased risk of
damage. Observe the minimum
clearances.
The electrical power supply is to
■
be adapted to the requirements
of the units.
The operational safety of the
■
units and components is only as-
sured if they are fully assembled
and used as intended. Safety
devices may not be modified or
bypassed.
Do not operate units or com-
■
ponents if there are obvious
defects or signs of damage.
. All housing parts and unit ope-
■
nings, e.g. air inlets and out-
lets, must be free from foreign
objects, liquids, or gases.
The units and components must
■
be kept at an adequate distance
from flammable, explosive,
combustible, abrasive and dirty
areas or atmospheres.
Contact with some parts of the
■
unit or components can result in
burns or other injuries.
Installation, repair and mainte-
■
nance work may only be carried
out by authorised specialists.
Visual inspections and cleaning
can be performed by the opera-
tor as long as the unit is discon-
nected from the power.
Take appropriate precautions
■
when performing installation,
repair or maintenance work or
cleaning the unit to make sure
the unit does not pose a danger
to persons.
The units and components
■
should not be exposed to any
mechanical load or extreme
levels of humidity.

Disposal of packaging

All products are packed for trans-
port in environmentally friendly
materials. Make a valuable con-
tribution to reducing waste and
sustaining raw materials. Only
dispose of packaging at approved
collection points.
Only recyclable materials are used
in the manufacture of the units
and components.
Help protect the environment by
ensuring that the units or com-
ponents (for example batteries)
are not disposed of in household
waste, but only in accordance with
local regulations and in an environ-
mentally safe manner, e.g. using
authorised disposal and recycling
specialists or council collection
points.

Liability

The manufacturer provides no
guarantee and shall not be liable in
the event of:
• Disregard of these instructions.
• Incorrect installation and/or use.
• Unauthorised modifications to the
product.
• Other incorrect use.
- 07.2020 / K410061801001-00 - 43/44
© www.kemper-olpe.de
EN
Environmental
protection and
recycling
Disposing of the units
and their components