Emptying The Coolant Buffer Tank - Kemper KHS CoolFlow Manuel D'utilisation

EN
6
If the quality of the coolant is no longer sufficient or the cooler is to
be relocated or dismantled, first drain the coolant buffer tank.
The coolant buffer tank (100 l) should be drained with the cooling
pump (13) and the bleeder valve (14).
Requirement:
• The coolant buffer tank must be completely filled to 100 l.
Hinweis!
If the coolant buffer tank has been partially emptied
beforehand, the cooling pump can no longer aspirate the
remaining coolant!
1
Disconnect the system from the
power supply and secure it against
being switched on again before
starting any work!
OFF
Info
Switch off the pump using the control
before unplugging!
3
52 / 144 – K410061000000-00 / 02.2022 – © www.kemper-olpe.de

Emptying the coolant buffer tank

4
2.
13
2
1.
5x
13 Cooling pump
14
14 Drain valve
Info
The hood can only be removed after the
plug has been removed. Work on live
components is therefore not possible. The
cold water chiller is thus disconnected
from the power source and protected
against restarting.