Acoustic Signals - Electrolux GA55GLV220 Notice D'utilisation

58 www.electrolux.com
• If the option is not applicable to the
programme, the related indicator flash-
es for some seconds and then stays
off.
5.2 Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse
aid and salt. The related indicators are off.
The programme duration can increase.
• Press the multitab button, the related
indicator comes on.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse
aid.

5.3 Acoustic signals

The acoustic signals operate in these
conditions:
• The programme is completed.
• The level of the water softener is adjus-
ted electronically.
• The appliance has a malfunction.
Factory setting: On.
It is possible to deactivate the
acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'Set-
ting and starting a programme'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4), (5) and (6) flash.
3. Press button (5),
• The indicators of buttons (3), (4) and
(6) go off.
• The indicator of button (5) continues
to flash.
• The display shows the current set-
ting of the acoustic signals.
4. Press button (5) to change the setting.
5. Deactivate the appliance to confirm
the setting.
5.4 Setting the Time Beam
colour
Nine colours are available for this light
beam. You can change the colour or de-
activate it.
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'Set-
ting and starting a programme'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4), (5) and (6) flash.
3. Press button (6).
• The indicators of buttons (3), (4) and
(5) go off.
• The indicator of button (6) continues
to flash.
• The display shows a number and
the letter C. Each number is related
to a different colour (0C = Time
Beam deactivated).
4. Press button (6) again and again to
change the colour.
5. Deactivate the appliance to confirm
the setting.
On
Off