Acoustic Signals - Electrolux ESI 8620RAX Notice D'utilisation

,
and the display is blank.
2. Press Delay.
• The indicators
and go off.
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid are
from 0A to 6A.
– Level 0 = no rinse aid is
released.
3. Press Delay again and again to
change the setting.
4. Press the on/off button to confirm the
setting.
6.4 The rinse aid empty
notification
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If you are using multi-
tabs containing rinse aid and you are
satisfied with the drying result, you can
deactivate the notification for refilling
rinse aid. However, we recommend that
you always use rinse aid for best drying
performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid
empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
,
and the display is blank.
2. Press Option.
• The indicators
go off.
• The indicator
continues to flash.
and start to flash
,
continues to
= level 4.
,
and start to flash
, and
• The display shows the current
setting:
notification is activated (factory
setting).
3. Press Option to change the setting.
= the rinse aid empty notification is
deactivated.
4. Press the on/off button to confirm the
setting.

6.5 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
,
and the display is blank.
2. Press Start
• The indicators
and go off.
• The indicator
flash.
• The display shows the current
setting:
3. Press Start to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm the
setting.
6.6 MyFavourite
With this option you can set and save the
programme that you use more
frequently.
ENGLISH
= the rinse aid empty
,
and start to flash
,
continues to
= Acoustic signal off.
11