Options; Energy Saver; Acoustic Signals; Multitab Function - Electrolux GA45SLV221 Notice D'utilisation

70 www.electrolux.com

OPTIONS

PROBOOST
Activate or deactivate the function
before the start of a programme.
You cannot activate or deactivate
this function while a programme
operates.
This function increases the water pressure
by 40% and gives better washing results
when dishes are very dirty.

ENERGY SAVER

Activate or deactivate the Energy
Saver function before the start of a
programme. It is not possible to
activate or deactivate this function
while a programme operates.
This function decreases the temperature in
the drying phase. The energy consumption
decreases by 25%.
The dishes can be wet at the end of the
programme.

MULTITAB FUNCTION

Activate this function only when you use
the combi detergent tablets.
This function deactivates the flow of rinse
aid and salt. The related indicators are off.
The programme duration can increase.
Activating the multitab
function
Activate or deactivate the multitab
function before the start of a pro-
gramme. You cannot activate or
deactivate this function while a pro-
gramme operates.
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press the multitab touchpad, the multi-
tab indicator comes on.
The function stays on until you de-
activate it. Press the multitab
touchpad, the multitab indicator
goes off.
All manuals and user guides at all-guides.com
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.

ACOUSTIC SIGNALS

The acoustic signals operate in these con-
ditions:
• The programme is completed.
• The level of the water softener is adjus-
ted electronically.
• The appliance has a malfunction.
Factory setting: on. You can deac-
tivate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold touchpads (4) and (5) at
the same time until the indicators of
touchpads (3), (4), (5) and (6) flash.
4. Press touchpad (5),
• The indicators of touchpads (3), (4)
and (6) go off.
• The indicator of touchpad (5) contin-
ues to flash.
• The display shows the setting of the
acoustic signals.
5. Press touchpad (5) to change the set-
ting.
6. Deactivate the appliance to confirm.
On
Off