Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10
www.electrolux.com
Whether you use a standard detergent
or multi-tabs (with or without salt), set
the proper water hardness level to
keep the salt refill indicator active.
Multi-tabs containing salt are
not effective enough to
soften hard water.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
flash and the display is blank.
2. Press
• The indicators
are off.
• The indicator
• The display shows the current
setting: e.g.
3. Press
setting.
4. Press the on/off button to confirm the
setting.
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If the drying results are
satisfactory while using multi-tablets only,
it is possible to deactivate the notification
for refilling rinse aid. However, for best
drying performance, always use rinse
aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
All manuals and user guides at all-guides.com
and
,
,
and
.
,
and
still flashes.
= level 5.
repeatedly to change the
How to deactivate the rinse aid
empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start flashing and the display is blank.
2. Press
• The indicators
off.
• The indicator
• The display shows the current
until
setting.
–
notification activated.
–
notification deactivated.
3. Press
4. Press on/off to confirm the setting.
6.4 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
flash and the display is blank.
2. Press
• The indicators
off.
and
,
,
and
.
,
and
still flashes.
= rinse aid empty
= rinse aid empty
to change the setting.
and
,
,
and
.
,
and
until
are
until
are
Publicité
Table des Matières
