Setting Of The Redox Control - Pool Technologie JUSTSALT UNO Manuel Utilisateur

4

SETTING OF THE REDOX CONTROL

This device controls the salt chlorinator production thanks to redox potential measure (ORP potential).
The redox understanding is sometimes delicate and often entails bad performances of the good functioning
of the device.
The redox measure in mV and informs about the sanitary quality of water.
According to several water parameters (particularly : the pH, the TAC, the rate of the stabilizing agent and
the general quality of water), the redox potential will not give the same corresponding of chlorine.
Then, a redox controller is not a chlorine regulator.
To maintain an optimum quality of the water, the redox method works on a reference space and compared
to the instruction point.
The chlorine pool demand varying constantly and the salt chlorinator process being slow, the redox value
measured by the device will be often different of the wished instruction value .
If by measuring regularly you notice a lack or an excess of chlorine (every pool water is different), calibrate
the redox instruction ; this to obtain an ideal value.
Check beforehand that the water parameters are imperatively respected.
Important :
For the protection and longevity of equipments of your pool, it is imperative to respect literally the
instructions of use mentioned in this manual. The presence of an amperometric chlorine regulation, of a
redox production controller or a pH regulation do not exempt from the strict respect of the instructions and
do not have authority to eliminate the risks and damages but only to limit them. Indeed, in spite of the
smooth running of a control or regulation device, other factors may cause damage, in particular :
- an insufficient ventilation in case of covered pool (shelter, tarpaulin, cover)
- a maintenance default of analysis probes (calibration, addition of the consumable...)
- manual processing of supplements excessive or not adapted (choc processing...)
- the non compliance with the instructions of use described in the present user manual
These isolated or organized factors will tend to cause oxidation on all metallic parts and of automatic cover
pins and slats, telescopic shelters and heat exchangers can lead to irreversible deterioration (discoloration)
of the pool lining.
Therefore, if the manufacturer's responsibility was engaged for a malfunction of the control or regulation
device, it would be limited to the repair or the replacement of the product free of charge. Then, it is strongly
recommended to check the levels of chlorine and pH each week with your usual analysis kit.
JUSTSALT UNO - JUSTSALT DUO - JUSTSALT PRO - PAPI004084MULTI1 - FR/EN/ES/IT - Rev.01.16
Your device is now ready.
16