4/ Parameters Setting; Control Panel - Pool Technologie JUSTSALT UNO Manuel Utilisateur

4/ PARAMETERS SETTING

1

CONTROL PANEL

pH /ORP regulation
control pad
ORP signal
Stand-by mode
To reach the setting menu : press 3 s on
 Select the function code using
The value flashes.
 Select the desired value using
The value is frozen and the device returns to the previous menu.
2
CONFIGURATION
Salt Chlorination Menu :
Code
Adjust the time of polarity inversion (allows to adapt the cleaning of the cell
In
frequencies according to the hardness of the water).
This device is equipped with an automatic cleaning of the chlorinator cell by a polarity
inversion in the borders of the cell. For an optimal cleaning, those inversion frequencies
must be adjusted according to your type of skin (normal water, hard or very hard).
Adjust your inversion frequencies :
TH (°f)
Inversion
frequencies
(hours)
Activate /Deactivate the pool cover function
If your Pool is equipped with a pool cover, the chlorine production must be reduced when
Co
the shutter is shut.
The device is supplied with a function that will take care of it automatically.
Forced march of the Salt chlorinator
rE
Allows forcing the salt chlorinator supply and then its production for a while fixed
Maintenance / Diagnostic of the failures parameters :
Adjust the temperature read by the device (see § 7.2, p. 40).
t°
Launch an auto diagnosis program (see § 7.1, p. 39).
tE
Activate / Deactivate the alarms (see § 7.3 p. 40).
AL
JUSTSALT UNO - JUSTSALT DUO - JUSTSALT PRO - PAPI004084MULTI1 - FR/EN/ES/IT - Rev.01.16
Duo/ Pro Version
REGULATION PH/REDOX PART
Duo - Display : pH current
value
Pro - Display :
pH signal
0 - 5 5 - 12
16
Uno Version
CHLORINATION SALT PART
Adjustment of the percentage
of chlorine production
Pro - Display :
Power signal
.
V
then confirm by
then confirm by
Function
12 - 20 20 - 40
10 8 6
.
V
.
V
40 - 60 > 60
4 2
Salt chlorinator
Control pad
Alarm signal
Stand-by mode
Setting
From 0 to 16 h
Pool cover shut
On/Of
11