Alarm/Wake-Up Function - Conrad 61 05 78 Mode D'emploi

Holding the manual temperature without limitation
• Set the desired temperature manually with „
hold down the corresponding button for an extended period of time.
„ " is displayed.
• Press the „
• The display shows the symbol „
• Confirm the setting with „

To terminate the manual temperature selection prematurely, press „
symbol „
curves programmed by you.
i) Alarm/Wake-up Function
Switching on the alarm/wake-up function, setting the alarm/wake-up time.
• Keep the button „
display.
• Press „ ". The pre-set alarm/wake-up time appears (e.g. „0:00") together with the
symbol „ ".
• Select the day block on which the wake-up sound is to be output with the buttons „
and „ ".
1 2 3 4 5
1 2 3 4 5 6 7
6 7
• Press „ ". The hours of the alarm/wake-up time flash.
Set the hours with the „
corresponding button for an extended period of time.
• Press „ ". The minutes of the alarm/wake-up time flash.
Set the minutes with the „
• Press „ " to return to the day block selection, if desired.
• Confirm the setting with „

If you do not press any button for an extended period of time, the settings are
stored automatically, and the device leaves the setting mode.
42
" button thrice.
".
" disappears, the room thermostat works again with the temperature
" pressed (approx. 3 seconds) until „AL" appears at the top of the
Monday to Friday
Monday to Sunday
Saturday and Sunday
" and „
" and „
". The device leaves the setting mode.
" and „
" and the alternating display of time/temperature.
" buttons. For quick adjustment, hold down the
" buttons.
". For quick adjustment,
". The
"