Setting The Heating Function, Off Or The Cooling Function; Heating Function (Switch Position: Heat) - Conrad 61 88 88 Notice D'emploi

• Connect your consumer in line with the
connection diagram shown on the right.
• Carefully place the top housing half onto
the bottom housing half.
• Reattach the attachment screws you
removed previously.
• Replace the previously removed knob.
Make sure that the dot marking points to
+5°C.
• Replace the main fuse into your fuse box
(in the case of screw lockings/ -automats)
or switch on the main fuse.
8. Setting the heating function, OFF or the
cooling function
Set the desired function of the thermostat with the "Function selection switch" (1).
a) Heating function (switch position: HEAT)
Use the heating function on cold days (e.g. in the winter).
If e.g. a heater is connected to the switch output HEATING (see connection diagram
chapter "6. Installation and connection"), this heater is activated or deactivated
depending on the set temperature threshold (adjustment via the "Temperature
adjuster" (2)).
Example for the switching mode for the heat function:
Set the "Temperature adjuster" (2) to +25°C.
This turns the heater on when the temperature falls 1 degree below 25°C. The
heater is turned off when the temperature rises 1 degree above 25°C.
24
Connection diagram: