Key Lock; Frost-Protection Mode; Reset - Conrad 61 05 78 Mode D'emploi

Switching off alarm/wake-up function
• Keep the button „
appear at the top of the display. The current alarm/wake-up time is also displayed.
• Press „ ". The symbol „
• Confirm the setting with „
up function is deactivated.
Stopping the alarm
When the alarm/wake-up signal sounds at the set time, press any button to stop it.
j) Key Lock
To activate the key lock, keep the button „
button symbols disappear from the display.
To deactivate the key lock again, keep the button „
seconds, until all button symbols appear again in the display.
k) Frost-Protection Mode

This function is only available if the room thermostat is in heating mode (see
Chapter 11. b).
• Press „ " repeatedly, until the display shows the snow-flake symbol „
• The room thermostat now works in frost protection mode and keeps the temperature
above 7 °C.
l) Reset
There is a small button on the PCB inside (see Chapter 7, Item 9).
Press it shortly to reset the room thermostat, e.g. when the buttons no longer react. As an
alternative, you can remove the inserted batteries for a few seconds and then replace them.
Except for the time, all data is retained during reset.
" pressed (approx. 3 seconds) until „AL" and the symbol „
" and the alarm/wake-up time disappear.
". The device leaves the setting mode. The alarm (wake-
" pressed for approx. 3 seconds, until all
" pressed again for approx. 3
"
".
43