Copy Function - Conrad 61 05 78 Mode D'emploi

e) Copy Function
If you want to assume, e.g., Monday's temperature curve for another or several other days,
it can be copied very easily. Therefore, you do not need to programme the same
temperature curve for several days.
Proceed as follows:
• Hold down the „
blocks starts flashing. „COPY" also flashes on the display. Then release the button.
• Select the day from which the data is to be copied with „
select any day block, but only a single day).
• Confirm the selection with „
• Now select the target with „
only a single day). The current temperature curve is shown at the bottom of the display.
• Confirm selection with „
curve appears at the bottom of the display.
• If the temperature curve selected in the beginning is to be transferred to another day,
select the other day with „
• Leave the copy mode with „
" button (approx. 3 seconds) until the weekday or one of the day
". The display „COPY" stops flashing.
" and „
" to copy the temperature curve data. The new temperature
" and „
".
" (This also must not be any day block, but
". Confirm your selection again with „
" and „ " (you cannot
".
39