Protecting Against Boiling Over; Overheating Protection - Pelgrim IDK584 Notice D'utilisation

safety

Protecting against boiling over

Overheating protection

GB 10
The appliance has a protection against boiling over.
• You will hear a beep signal and a symbol
display. The appliance automatically switches off. This can be for
one of the following reasons:
▷ Boiling over where the operating buttons are covered.
▷ Damp cloth on the buttons.
▷ Metallic object on the operating buttons.
• Clean the appliance or remove the metallic object.
The appliance may become overheated if:
• the pan does not conduct the heat adequately;
• fat or oil is heated at a high setting;
• there is insufficient circulation of air (see also ventilation protection
in the installation part of this manual).
In the event of overheating the result will be that the cooking zone
in question or all the cooking zones will display one of the following
reactions:
• the hob will reduce the power supplied slightly (this is not visible in
the cooking settings in the displays);
• if this does not help, the hob switch off and a series of dashes will
appear in the displays.
As soon as the cooking zone(s) has/have cooled down sufficiently, the
dashes disappear and the cooking zones remain switched off.
Prevent the overheating protection becoming activated by:
• using pans that are good conductors of heat;
• heating up fat or oil at a lower setting;
• making sure there is sufficient ventilation.
If, despite the above-mentioned measures having been taken, the
overheating protection becomes activated again, contact the service
department or a professionally qualified specialist.
appears on the