Setting Up The Massage Lounger; Accessories - Panasonic EP-MA73 Mode D'emploi

Setting up the massage lounger

1
Where to use the unit
●
Ensure there is adequate space to recline.
Keep at least 10 cm (3.9 in.) away from the wall.
Approx. 202 cm (79.5 in.)
Width approx.
90 cm (35.4 in.)
Approx. 49 cm
(19.3 in.)
Mat Area where leg rest
could touch the floor
●
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front
of heating sources, because this can cause discoloration or hardening of the synthetic leather.
●
Place the unit on a mat to prevent floor damage. When placing a mat under the unit, the size
of the mat should be sufficient (at least 120 cm × 70 cm (47.2 in. × 27.6 in.)) to cover the
areas where the unit touches and where the leg rest could touch the floor, as shown in the
diagram on the above.
●
Install the unit near a power outlet.
2
Confirm that the main unit and the accessories are in the box.
Main unit
Controller
EN14
Approx. 30 cm
(11.8 in.)
Area where unit
touches the floor

Accessories

●Pillow
●Armrests (Right/Left)
●
C omfort
cushion
Right/Left indication
(Back of the armrest)
The holes in the fabric
at the back of the
●
P ower cord
hand & arm massage
section are due to
the manufacturing
process and are not
a fault.
●
For details on the dimensions of the unit, see
page EN9.
●
●    A llen key — 1
A ttachment screws
(M6 × 13) — Black

(M6 × 29) — Silver
(Cross-section)
4 mm
●Controller stand
Controller
●Lock switch key
holder
Controller
holder fixing
screw
This is initially inserted
in the lock switch of the
Clip
power switch section
prior to leaving the
factory.
(4 pcs.)
(2 pcs.)