When the controller stand is attached on the left side
●Run the controller cord to the left.
① Press
on the controller to turn on the power.
② Press
on the controller and hold until the leg rest has
risen as far as it will go.
・ Continue pressing until a "beep-beep-beep" sound is heard.
③ Disconnect the controller cord.
・ Hook is released by pressing on the tab on the fastening
band with your fingers.
④ Move the controller cord under the leg rest to the left side.
⑤ Fasten the controller cord.
・ Press down from the edge if it does not fit in easily.
⑥ Insert the tip of the fastening band into the hole.
●
The controller cord is fastened to the right side prior to
leaving the factory.
Fastening band
③
Tab
7
Fasten the pillow and the comfort cushion.
❶
●
Fasten the pillow using
the fasteners.
●
See page EN23 for guidelines
on positioning the pillow
during the massage.
Fasteners
Pillow
Fasten to the right side
③
Controller cord
④
❷
●
Fasteners
Leg rest
View from
front
Fasten the comfort cushion using
the zipper.
②
Cord-holder groove
⑤
●
⑥
●
Controller cord
Zipper
Comfort cushion
EN19