Setting Up The Massage Lounger; Installing The Unit - Panasonic EP-MA70 Mode D'emploi

Setting up the massage lounger

1 Where to use the unit
• Ensure adequate space to recline.
• Do not expose the massage lounger to direct sunlight or high
temperatures, such as in front of heating sources, because this can cause
discolouration or hardening of the synthetic leather.
• Place the unit on a mat to prevent fl oor damage.
• When placing a mat under the unit, the size of the mat should be suffi cient
[at least 47.2 in. × 27.6 in. (120 cm × 70 cm)] to cover the areas where the
unit touches and where the legrest could touch the fl oor, as shown in the
diagram on the right.
• Install the unit near a power socket.
See Warning No. 11 and 12 on page 1, and Caution No.23 on page 3.

2 Installing the unit

Hold onto the sides.
Do not hold onto
the front side.
The sole massage
section might slide,
and injuries may
occur.
11
Hold onto the
sides of the
legrest.
Place your
fi ngers in the
groove
Back cover
Legrest
Keep at least 4" (10 cm) away from the wall.
Approx. 79.6" (202 cm)
Width approx. 37.4" (95 cm)
Approx. 19.3"
(49 cm)
Mat Area where legrest
could touch the fl oor
• Since the unit is very heavy [approximately
191.8 lbs (87 kg)], be careful to avoid back
injuries. (The unit must be carried by two or
more persons.)
To put the unit down on the
fl oor
• Put the unit down slowly and carefully
watch your step.
• Put down the legrest by holding it with your
Groove
hands until it has been set on the fl oor
completely. If you release your hands before
the legrest is fully extended, the legrest will
forcefully return to the initial position.
• The fl oor may get damaged, so it is
recommended to place a mat etc. on the
fl oor.
See Caution No.22 and 23 on page 3.
Mat
Approx.
11.8"
(30 cm)
Area where unit touches
the fl oor