Alarm Function - geo-FENNEL FL 1000 HP Mode D'emploi

EN
USE OF RECEIVER FR 10
To prolong the working range FL 1000 HP can be used with the receiver FR 10 (supplied with the kit).
Press key for 2 sec. FR 10 can now detect the signal of FL 1000 HP . Lamp is lighting.
Press key again for 2 sec. to switch off the receiver mode. Further information regarding the use of
the receiver is on p. 18.

ALARM FUNCTION

An audible alarm indicates if the instrument was set up outside of the self-levelling range (± 5°).
The vertical lines and the laser dot are blinking at the same time.
REMOTE CONTROL
The FL 1000 HP can also be remote controlled. The keys of the remote control are identical to the keys
of the instrument. The range of the remote control is 50 m max.
Note: If the stand-by function is activated all keys are inactive - except the ON/OFF knob.
APPLICATION
The FL 1000 HP can be run on an even surface, on the floor mount supplied with as well as on a tripod
with 5/8" connection. For this, screw off the floor tripod of the instrument.
17