Switch-On And Switch-Off - Waldmann CHORUS LCS 455/2 Mode D'emploi

Instructions for Use Uplighter LC(S/T/A) 455 „CHORUS"
GB
Operation - Version LC* /P
Fig. 20
20.7
20.6
20.8
20.9
LC* = LCS, LCT, LCA
Operation
Via the two keys [20.8 and 20.9] on
the sensor, different functions can
be activated depending on which
key is pressed:

- Switch-on and switch-off

- Changing light level
- Dimming the light
- Light control
- Presence control
- Basic settings
In-factory setting
The lights are set in-factory so that initially they can be operated without changing the settigs. For adapting the
light to your individual demands, the parameterization functions (see "Basic settings" , page 40-41) and control
parameters (see "Light control" , page 38) can be changed accordingly.
Switching on
Briefly press the front key, the light
will switch to light level 1 (front LED
lights up in red).
Briefly press the rear key, the light
will switch to light level 2 (rear LED
lights up in red).
Switching off
Press the key on which the red
LED is lit.
Switching over
For changing from one light level to
the other, press the key on which
the LED is not lit.
Changing the light level (dim-
ming)
Press the front key (level 1) or
the rear key (level 2) and keep it
depressed. The appertaining LED
starts flashing after approx. 2
seconds and the light changes the
intensity.
To change the dimming direction,
briefly release the key (< 1 sec.)
and press it again.
Upon reaching the upper or lower
limit, the LED flashes more slowly,
and the intensity changes direc-
tion.
The present light intensity is stored
when you release the key.
37