AL-KO Moweo 42.0 Li Mode D'emploi page 30

GB
See:
■
Operating instructions
441630: Li-ion rechargeable
battery B150 Li (B05-3640G),
B200 Li (B05-3650G)
■
Operating instructions
441633: charger C130 Li
(C05-4230)
4 INSTALLATION
WARNING! Danger if assembly is not
carried out completely! Operation of an incom-
pletely assembled appliance can result in serious
injury.
■
Only operate the appliance when it is fully as-
sembled.
■
Do not insert the battery into the appliance
until it is fully assembled.
■
Check that all safety and protective devices
are in place and functioning correctly before
switching on.
5 START-UP
5.1 Charging the rechargeable battery (02)
The following li-ion rechargeable batteries and
charging units can be used:
Product Designation
Li-ion re- B150 Li
chargeable (B05-3640G)
battery
Li-ion re- B200 Li
chargeable (B05-3650G)
battery
Charging C130 Li (C05-4230)
unit
The rechargeable battery is partially charged.
Fully charge the rechargeable battery before us-
ing it for the first time. The rechargeable battery
can be charged in any charge status. Interrupting
charging does not damage the rechargeable bat-
tery.
NOTE For detailed information, heed the
separate operating instructions for the recharge-
able battery and for the charging unit.
30
CAUTION! Danger of fire during
charging! Due to heating of the charger, there is
a danger of fire if it is placed on an inflammable
surface and is not adequately ventilated.
■
Always use the charger on a non-inflamma-
ble surface or in a non-combustible environ-
ment.
■
If available: Keep the ventilation slots free.
1. Insert the rechargeable battery (02/1) in the
charging unit (02/2) and plug the power plug
(02/3) into the power outlet. The charging
process begins and the LED for indicating the
operating status (02/4) flashes green.
2. Observe the LED (02/4). The charging pro-
cess takes approx. 1.5 – 2.0 hours until fully
charged. The charging process ends auto-
matically when the rechargeable battery is
fully charged. The LED (02/4) then lights per-
manently green.
3. Disconnect the power plug (02/3) when the
LED (02/4) permanently lights green.
4. Press and hold the engaging button on the
bottom of the rechargeable battery.
5. Pull the rechargeable battery (02/1) out of the
charging unit (02/2).
Status displays on the charging unit (03)
The LED (03/1) on the charging unit indicates the
charge status of the rechargeable battery and the
operating condition of the charging unit. The sym-
bols (03/2) on the charging unit indicate these
states:
Item no.
Symbol LED and charge status
113280
113524
113281
5.2 Determining the charge state of the
rechargeable battery (04)
There is a control panel with a pushbutton (04/1)
and LED charge status displays (04/2 to 04/5) on
the front of the rechargeable battery.
LED lights green: The rechargeable
battery is fully charged.
LED flashes green: The recharge-
able battery is charging.
LED lights red: There is no recharge-
able battery in the charging unit.
LED flashes red: The rechargeable
battery is too hot and will therefore
not charge.
Installation