Horizon Fitness T82 Manuel Du Propriétaire page 4

ASSEMBLY STEP 1
HARDWARE FOR STEP 1
LONG BOLT (A) SHORT BOLT (B)
M8 X 50L M8 X 16L
QTY: 4 QTY: 2
ARC WASHER (C) FLAT WASHER (D)
Ø 8 Ø 8
QTY: 2 QTY: 4
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
b
c
a d
MAIN FRAME BRACKET
6
A A Open the box and remove all parts underneath
the running deck by lifting the running deck
upward.
B Open HARDWARE PARTS for Step 1
C Align and attach LEFT CONSOLE MAST with base
frame bracket by using 2 LONG BOLTS (A),
1 SHORT BOLTS (B), 2 FLAT WASHERS (D) and
1 ARC WASHER (C).
D Connect the CONSOLE CABLES at RIGHT
CONSOLE MAST and carefully tuck wires to
CONSOLE MAST to avoid damage.
E Repeat Step C on the RIGHT CONSOLE MAST.
NOTE: Do not pinch or break any wire when
assembling the console mast. You may need
extra help assembling step 1 o 2 and DO NOT
fully tighten the bolts until step 2 is completed.
ASSEMBLY STEP 2
HARDWARE FOR STEP 2
SHORT BOLT (B) ARC WASHER (C)
M8 X 16L Ø 8
QTY: 4 QTY: 4
c
b
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
A Open HARDWARE PARTS for Step 2
B Gently hold the CONSOLE above the CONSOLE
MAST.
C Connect the CONSOLE CABLES at right hand
side, carefully tucking wires in RIGHT CONSOLE
MAST to avoid damage.
Attach the to the
D CONSOLE CONSOLE
MAST using 4 SHORT BOLTS (B) and 4 FLAT
WASHERS (C).
NOTE: Console fixing from beneath. Be careful
not to pinch any wires and make sure you
fully tighten all bolts before starting using the
treadmills.
7