Horizon Fitness T82 Manuel Du Propriétaire page 3

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GRIP PULSE HANDRAILS
HANDLEBARS
CONSOLE MAST
MOTOR COVER
TRANSPORT WHEEL
RUNNING BELT / RUNNING DECK
SIDE RAIL
4
WATER BOTTLE HOLDER
CONSOLE
SAFETY KEY PLACEMENT
ON/OFF SWITCH
CIRCUIT BREAKER
POWER CORD
S/N STICKER
REAR ROLLER TENSION / ADJUSTMENT BOLTS
PRE ASSEMBLY
TOOLS INCLUDED:
F 5 mm L-Wrench /screwdriver
F 6 mm L-Wrench
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place
PARTS INCLUDED:
a protective covering on your floor. Take CAUTION when handling and transporting
this unit. Never open box when it is on its side. Once the banding straps have been
F 1 Console Assembly
removed, do not lift or transport this unit unless it is fully assembled. Unpack and
F 2 Console Masts
assemble the unit where it will be used. Never grab hold of any portion of the incline
frame and attempt to lift or move the treadmill.
F 1 Hardware Kit
F 1 Safety Key
F 1 Power Cord
WARNING
F 1 Silicone
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You
may remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NEED HELP?
If you have questions or if
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
there are any missing parts,
partially threaded in before completely tightening any ONE bolt.
contact your local dealer.
NOTE: A light application of grease may aid in the installation of hardware. Any
grease, such as lithium bike grease is recommended.
5

Publicité

Table des Matières
loading

Table des Matières