Steba IK 3500 Flex Mode D'emploi page 27

Troubleshooting
Dear Client,
Thank you for buying this STEBA product. The following table will help you with
problems that may occur when using your device. For many problems there is a sim-
ple solution, because not everything that appears like a malfunction must be serious.
Please check the following list before contacting our customer service.
Problem
No light after plug-in of
the device
A signal tone sounds
and no heat occurs
Plate does not heat
anymore
Error code „E0"
Error code „E1"
Error code „E2"
Error code „E3"
Reason
∙ No power
∙ To many devices at one
power cord
∙ Pot not suitable for in-
duction
∙ Timer run out
∙ No or inappropriate
cookware
∙ Internal overheat
∙ The temperature of the
pot is too high
∙ Voltage is unusual
Solution
∙ Check is plug is plugged-
in correctly
∙ Check the fuse
∙ Min. diameter of 10cm
∙ Use suitable cookware
∙ Set a new time
∙ Check cookware
∙ Let device cool down and
restart
∙ Take the pot from the de-
vice and let it cool down,
then restart
∙ Let device cool down and
restart
27