EUROM HEAT AND BEAT Mode D'emploi page 18

Alongside the comfortable 2000W heat, the Golden ULG lamp also emits a natural, warm,
subtle glow. The lamp has an expected life of 8,000 hours; under normal circumstances, it
should not have to be replaced.
Very intensive use can lead to precocious aging of the lamp and of course an accident can
break it. In that case, contact your dealer or a qualified electrician. The lamp has a special
connection and it is not allowed to not-qualified people to remove or change it.
INSTALLATION
Caution! The model in the photo may differ from the model you have purchased. Both
models are installed in the same way.
Before installing, secure the hanging bracket (11) to the heater. Using the Allen key, undo the
Allen screw (12) and pull the pin with the other screw out of the hole. Place the hanging bracket
(11) between both holes as indicated on the diagram. Push the pin with the second screw back
through the holes and the hanging bracket. Then place the first Allen screw back and turn to
secure using the Allen key.
The EUROM HEAT AND BEAT can be installed in three ways:
 Suspension from a wall (or possibly ceiling) by means of a wall bracket
 Suspension from a frame (parasol, tent or similar item) by means of a bracket
 Suspension from a ceiling by means of chains
Remove all package material (including the shock absorbing material around the bulb) before
installating the heater and check the appliance, supply cord and the plug for signs of damage.
Carefully choose the right place to install your heater.
Before fastening, check that the minimum safe distances between the surroundings and the
chosen location are respected:
Minimum distance lowest point of heater – floor: 1,8 metres
Minimum distance heater – heated object: 1 metre
Minimum distance top* heater – fire-resistant ceiling: 0.25 metres
Minimum distance top* heater – tent tarpaulin, parasol etc.: 0.5 metres
Minimum distance side heater – walls, obstacles, objects: 0.5 metres
* The top of the heater is the side where the suspension bracket is attached.
If you suspend the device outside, ensure that it is protected from the wind.
1 – Suspension from a wall (or possibly ceiling) by means of the wall bracket
 The appliance has to be mounted preferably on an incombustible foundation. That foundation
has to be vibrationfree, exact vertical and stable enough for lastingly holding the appliance
free of problems. Check or the provided dowels and
screws are suitable, strong enough and qualified for the
foundation. The material provided is identified for a brick
wall; for another foundation please ask the specialist for
suitable material.
 Fix the mounting bracket totally horizontal on the wall
with the four anchor dowels provided see fig.
18