EUROM HEAT AND BEAT Mode D'emploi page 19

 Hang the terrace heater with the suspension bracket
in the wall bracket. Refer to the picture. Slide the
bracket through the wall bracket as far as possible –
the small hole in the bracket protrudes under the wall
bracket. Secure that terrace heater by screwing the
short wing nut supplied as far as possible into the
small hole in the suspension bracket.
2 – Suspension from a frame (parasol, tent or
similar item) by means of a bracket
 Ascertain that the frame from which you wish to
suspend the terrace heater is strong enough to take
the weight of the terrace heater for an extended period
of time.
 Choose which of the three supplied brackets is
suitable for the frame. You must choose the smallest
possible option.
 Slide the bracket around the frame, place the terrace
heater against it and screw the bracket to the
suspension bracket with 2 wing nuts (see picture).
3 – Suspension from a ceiling by means of chains
 Choose 2 suspension points in the ceiling, 40 cm
apart. Ascertain that the ceiling and fastening
materials are strong enough and suitable to take the
weight of the heater for an extended period of time.
 Fasten the suspension eyes to the ceiling (not
supplied).
 Hook one end of the chains onto suspension points of
the heater by means of the karabiner hook. You hook
the karabiner hooks at the other end of the chain
through the suspension eyes in the ceiling. Pulling the
chain through the suspension eye and fastening the
second karabiner hook to the chain allows you to raise
the suspension height of the heater. You can also
wrap the chain around a horizontal beam or rod (see picture).
Please always take account of the minimum distances to the ceiling, floor, walls and objects
and make sure the heater is horizontal!
The following applies for all options:
 However you install the GOLDEN AMBER SMART, always lead the electrical cable
directly away from the heater. It may not become hot!
 Adjust the desire radiation angle of the device. Do this by undoing both Allen screws slightly
using the Allen key. Make sure you secure them again once you have made the adjustments!
19