EUROM Mon Soleil 350 Manuel D'utilisation page 46

Removing a specific timer setting
1. Press the WEEK button for three (3) seconds, until the display shows the
flashing UU.
2. Press the SET button and the display will show your flashing selection of
ON/OFF (timer on or off).
3. Press the SET button again and the display will show your flashing selection of
01/99 (only once or endlessly).
4. Press the SET button again and the display will show the flashing U1 (day 1).
5. Using the + and/or – buttons, select the day for which you want to remove a
specific timer setting.
6. Press the EDIT button.
7. Using the + and/or – buttons, select the number of the timer setting that you
want to remove.
8. Pressing the C (Cancel) button will erase the timer setting concerned.
Checking the timer settings using the remote control
Press the WEEK button a few times briefly. You will see the following settings in
sequence:
1. Timer ON or Timer OFF
2. Once only (01) or endlessly (99)
2. U1-U7, day of the week
3. Timer setting number of the day concerned (1, 2, 3 or 4)
4. The set temperature of the thermostat
5. Start time in hours
6. Stop time in hours
This is repeated for the next timer settings.
All 28 timer settings are shown, also the timer settings that have not been filled.
The temperature of the non-filled timer settings is 20 °C.
Open-window detection system (not applicable for Wi-Fi control)
Press the button on the remote control. The
heater's display.
If the ambient temperature decreases 8°C or more within 15 minutes, the heater
will turn off and the related symbol will flash.
If this is the case and you press this button again, the heater will resume its normal
operation.
ECO button
If the ECO button on the remote control is pressed, the display will show EC. The
heater will start to heat if the ambient temperature drops to below 16 °C and will
turn off if the ambient temperature increases to above 16 °C. Pressing the ECO
button again will switch off the ECO mode.
symbol will appear on the
46