EUROM Mon Soleil 350 Manuel D'utilisation page 40

 To remove the panel from the wall, you must slide in the opposite direction and
lift, until the knobs are in front of the eyes again. Now you can take the panel
off.
Note: Guide the electric cable and the thermostat cable (if applicable) immediately
downwards and make sure that they do not come into contact with the panel. Do
not conceal any surplus cable behind the heater!
Use and Working
Control panel:
1. Main switch & pilot light
2. Temperature sensor
3. Display
4. Up/down key
5. ON/OFF switch
6. button M
7. Connection external temperature sensor
External temperature sensor (7)
Display (3)
a. Temperature / Data
b. Heating symbol
c. Open-window detection symbol
d. WiFi symbol
e. Capacity indication symbol
Because the temperature sensor is located on the heater, it
does not measure the external temperature very accurately. If
you want accurate measuring, connect the separate thermostat
(included in the delivery) by inserting the small plug into the
control panel and placing the sensor approx. 2 metres away
from the heater (see illustration). For this purpose, you should
remove the heater from the wall and subsequently, place it
back. When you have connected the separate thermostat, it
automatically takes over the thermostat operation.
40