EUROM Mon Soleil 350 Manuel D'utilisation page 45

14 + or –
15 OK
16 TIME ON
17 + or –
18 OK
19 TIME OFF
20 + or –
21 OK
Timer setting(s) is/are entered; the ambient temperature will appear on the
display after three (3) seconds.
Attention (1):
The timer setting(s), which you make under 'once only (01)', should be made for
the current week. On Sunday (day 7) at 24.00, all 'once only' setting(s) are set to
'non-active'. Therefore, a timer setting for Saturday that you made on Tuesday will
work, but a timer setting for Tuesday that you make on Saturday will not work!
Attention (2):
If a timer setting with number 01 was made for this day, you must manually set
the next timer setting for this day to 02 using the + button, otherwise the timer
setting 01 will be overwritten.
Attention (3):
Start & stop times can only be entered in whole hours (not in minutes).
Removal of timer settings using the remote control
Removing all timer settings
1. Press the WEEK button for three (3) seconds, until the display shows the
flashing UU.
2. Pressing the C (Cancel) button will erase all timer settings.
Removing all timer settings of a specific day
1. Press the WEEK button for three (3) seconds, until the display shows the
flashing UU.
2. Press the SET button and the display will show your flashing selection of
ON/OFF (timer on or off).
3. Press the SET button again and the display will show your flashing selection of
01/99 (only once or endlessly).
4. Press the SET button again and the display will show the flashing U1 (day 1).
5. Using the + and/or – buttons, select the day for which you want to remove the
timer settings.
6. Pressing the C (Cancel) button will erase all timer settings of the day concerned.
The selected
temperature
HE flashes
The selected start
time
HF flashes
The selected stop
time
Set the desired temperature (0 °C to
37 °C). The default setting is 20 °C.
Set the desired start time from 00.00
to 23.00 [see Attention (3)].
Set the desired stop time from 00.00
to 23.00 [see Attention (3)].
45