Electrical Connections - Camille Bauer EURAX V 604 Mode D'emploi

Setting of trip point
by PC: Programmable
– between – 10 and 110%
(on the measured variable)
– between ± 1 and ± 50%
(for a change of the measured
variable)
Reset ratio: Programmable
– between 0.5 and 100%
(on the measured variable)
– between 1 und 100%
(for a change of the measured
variable)
Operating and
resetting delays: Programmable
– between 1 and 60 s
Operating sense: Programmable
– Relay energised, LED on
– Relay energised, LED off
– Relay de-energised, LED on
– Relay de-energised, LED off
(once limit reached)
Relay status signal: GW by red LED (
Light emitting diodes
Table 3: Red LED , ( )
Operating modes
( (
Open-circuit sensor
or lead
Above or below
limit 2 GW
Table 4: Green LED ON
Operating modes
Switching on
Normal operation
Out of range
Automatic lead compen-
sating using calibration
button S1
Open-circuit sensor
EEPROM data bit error
(self-test error)
Power supply failure
1 In relation to analogue output span A.
2
Only applies when the output contact K is used for monitoring the
input variable in relation to a limit.
1
1 /s
1
1 /s
)
Red LED
lit
lit / not lit
(acc. to programming)
Green LED
Flashes at 1 Hz for
5 seconds after switching
on power supply
Continuously lit
Flashes at 1 Hz
Flashes at 2 Hz
Flashes at 1 Hz
Flashes at 1 Hz
Extinguished
Accuracy (acc. to DIN/IEC 770)
Basic accuracy: Limit of error ≤ ± 0.2%
Ambient conditions
Commissioning
temperature: – 10 to +55 °C
Operating temperature: – 25 to +55 °C, Ex – 20 to +55 °C
Storage temperature: – 40 to +70 °C
Relative humidity
of annual mean: ≤75% for standard climatic rating
≤95% for enhanced climatic rating
Programming connector
Interface: RS 232 C
FCC-68 socket: 6/6 pin
Signal level: TTL (0/5 V)
Power consumption: Approx. 50 mW

6. Electrical connections

The transmitter EURAX V 604 is inserted in a 19" rack.
The following instructions enable the connections to be
made to the rack without error ...
... when directly connected (to the socket in the rack)
or
... when connecting to terminals on the rack (screw
terminals, rack connector, multiplug etc.) after
completion of unit allocation and wiring diagrams.
Where EURAX V 604 is delivered in a pre-wired rack, unit
allocation and wiring diagrams must be enclosed.
Make sure that the cables are not live when
making the connections!
The 230 V power supply and 125 V contact
output is potentially dangerous
23