Operation; Settings; Changing Tools - Festool CARVEX PS 400 EBQ Notice D'utilisation D'origine

PS 400 EBQ
Sawing wood
Handle a = 6.0 m/s
h
K = 2.0 m/s
Gear a = 11.0 m/s
h
head
K = 2.0 m/s
Sawing metal
Handle a = 7.0 m/s
h
K = 2.0 m/s
Gear a = 12.0 m/s
h
head
K = 2.0 m/s
The emission values specified (vibration,
noise) were measured in accordance with the
test conditions stipulated in EN 60745 and
are intended for machine comparisons. They
are also used for making preliminary esti-
mates regarding vibration and noise loads
during operation.
The emission values specified refer to the
main applications for which the power tool is
used. If the electric power tool is used for
other applications, with other tools or is not
maintained sufficiently prior to operation,
however, the vibration and noise load may
be higher when the tool is used. Take into ac-
count any machine idling times and down-
times to estimate these values more accu-
rately for a specified time period. This may
significantly reduce the load during the ma-
chine operating period.
6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident
X
The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
X In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
Connecting and detaching the mains power
cable [1-7] see Fig. [2].
X Insert the plug into a socket.
The electric power tool has one button
on each side for switching on/off.
PSB 400 EBQ
2 2
a = 10.0 m/s
h
2 2
K = 2.0 m/s
2
2
2 2
a = 11.0 m/s
h
2 2
K = 2.0 m/s
2
2
[1-2]
The PSB 400 EBQ also has a variable speed
trigger [1-3] with switch lock [1-4]. For con-
tinuous operation, use the button [1-2].
7

Settings

WARNING
Risk of injury, electric shock
X
Always pull the plug out of the socket be-
fore performing any type of work on the
machine!
7.1

Changing tools

CAUTION
Hot and sharp tools
Risk of injury
X Wear protective gloves!
Selecting saw blade
Only use saw blades with a T-shank.
The saw blade should not be longer
than that required for the intended cut.
To ensure safe guidance, during the cut the
saw blade should emerge at the bottom of
the workpiece at every point.
L Only use cross-set saw blades when using
the angle and adapter table. We recom-
mend Festool saw blade S 105/4 FSG.
Inserting saw blade
Always pull the mains plug out of the
socket before changing blades.
X
If necessary, push the chip guard
upwards.
X Push the saw blade
as far as the stop with its teeth in cutting
direction [3-2].
X Turn the saw blade
clockwise until it engages.
The guidance jaws adjust automatically to
the saw blade used.
Check that the saw blade is secure. A
loose saw blade can fall out and cause
an injury.
L In the case of very short saw blades, it is
advisable to remove the saw table (see
chapter 7.4) before inserting the saw
blade.
CARVEX
GB
[3-1]
[3-4] into the opening
[3-4] approx. 30°
15