Operation; Settings; Changing Tools - Festool CARVEX PS 400 EBQ Mode D'emploi

CARVEX
GB
PS 400 EBQ
Sawing wood
Handle a =6,0 m/s
h
K = 2,0 m/s
Gear a =11,0 m/s
h
head
K = 2,0 m/s
Sawing metal
Handle a =7,0 m/s
h
K = 2,0 m/s
Gear a =12,0 m/s
h
head
K = 2,0 m/s
The emission values specified (vibration,
noise) were measured in accordance with the
test conditions stipulated in EN 60745 and are
intended for machine comparisons. They are
also used for making preliminary estimates re-
garding vibration and noise loads during oper-
ation.
The emission values specified refer to the
main applications for which the power tool is
used. If the electric power tool is used for oth-
er applications, with other tools or is not main-
tained sufficiently prior to operation, however,
the vibration and noise load may be higher
when the tool is used. Take into account any
machine idling times and downtimes to esti-
mate these values more accurately for a spec-
ified time period. This may significantly reduce
the load during the machine operating period.
6

Operation

WARNING
Unauthorised voltage or frequency!
Risk of accident
X
The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
X
In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
Connecting and detaching the mains power
cable [1-7] see Fig. [2].
X Insert the plug into a socket.
The electric power tool has one button
on each side for switching on/off.
16
PSB 400 EBQ
2 2
a =10,0 m/s
h
2 2
K = 2,0 m/s
2
2
2 2
a =11,0 m/s
h
2 2
K = 2,0 m/s
2
2
[1-2]
The PSB 400 EBQ also has a variable speed
trigger [1-3] with switch lock [1-4]. For con-
tinuous operation, use the button [1-2].
7

Settings

WARNING
Risk of injury, electric shock
X
Always pull the plug out of the socket be-
fore performing any type of work on the
machine!
7.1

Changing tools

CAUTION
Hot and sharp tools
Risk of injury
X Wear protective gloves!
Selecting saw blade
Only use saw blades with a T-shank. The
saw blade should not be longer than
that required for the intended cut. To
ensure safe guidance, during the cut the saw
blade should emerge at the bottom of the
workpiece at every point.
L Only use cross-set saw blades when using
the angle and adapter table. We recom-
mend Festool saw blade S 105/4 FSG.
Inserting saw blade
Always pull the mains plug out of the
socket before changing blades.
X
If necessary, push the chip guard
wards.
X Push the saw blade
as far as the stop with its teeth in cutting
direction [3-2].
X Turn the saw blade
wise until it engages.
The guidance jaws adjust automatically to the
saw blade used.
Check that the saw blade is secure. A
loose saw blade can fall out and cause
an injury.
L In the case of very short saw blades, it is
advisable to remove the saw table (see
chapter 7.4) before inserting the saw
blade.
[3-1]
[3-4] into the opening
[3-4] approx. 30° clock-
up-