Additional Specific Safety Rules; Background Information; Dovetail And Box Joint Overview - Porter Cable 4210 Manuel D'instructions

16. AVOID UNINTENTIONAL STARTING. Do not carry a plugged-in tool with finger on switch. Be sure switch is off
when plugging in. Keep hands, body and clothing clear of blades, bits, cutters, etc. when plugging in the tool.
17. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only extension cords marked "Suitable
for use with outdoor appliances – store indoors when not in use." If an extension cord is to be used outdoors it
must be marked with the suffix W-A or w following the cord type designation.
18. STAY ALERT. Watch what you are doing. Use common sense. Do not operate tool when you are tired or while
under the influence of medication, alcohol or drugs.
19. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect
its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced
by authorized service center. Do not use tool if switch does not turn it on and off.
20. WEAR ANSI S3.19 EAR PROTECTION to safeguard against possible hearing loss.
FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS in the instruction manual supplied with your router.
2. SECURE WORK. Be sure Dovetail Fixture/Jig and work is anchored securely to prevent movement.
3. BE SURE CORD SET IS FREE and will not hang up during routing operations.
4. KEEP HANDS CLEAR of cutter when motor is running to prevent personal injury.
5. MAINTAIN FIRM GRIP on router when starting motor to resist starting torque.
6. STAY ALERT and keep cutter free, clear of all foreign objects while motor is running.
7. BE SURE MOTOR HAS COMPLETELY STOPPED before removing router from Dovetail Fixture/Jig and setting
Dovetail Fixture/Jig down between operations.
8. NEVER REMOVE ROUTER MOTOR from router base while template guide and dovetail bit are installed. dovetail
bit may not fit through hole in template guide.
9. TIGHTEN TEMPLATE GUIDE LOCKNUT SECURELY.
10. SOME WOOD CONTAINS PRESERVATIVES WHICH CAN BE TOXIC. Take extra care to prevent inhalation and
skin contact when working with these materials. Request, and follow, any safety information available from your
material supplier.
REPLACEMENT PARTS
When servicing use only identical replacement parts.

DOVETAIL AND BOX JOINT OVERVIEW

The dovetail joint is a traditional joint that is both strong and visually appealing. This joint has flared protrusions (tails) that are cut
into one board (drawer side) and protrusions with slanted sides (pins) that are cut in the other board (drawer front or back). When
the two pieces are joined, the tails and pins lock together mechanically, so that pulling on the drawer front will pull the drawer side
as well without the need for fasteners (screws, nails, etc.). Since the pins and tails have a sufficient amount of surface, the joint is
even made stronger by glue.
Types of dovetails include through dovetails, half-blind dovetails, rabbeted half-blind dovetails, mitered-through dovetails, blind
dovetails, and mitered dovetails. Of these joints, the through, half-blind, and rabbeted half-blind are the most common.
NOTE: This manual includes instruction for the basic dovetail jig operations. Please visit our Web Site at www.del-
taportercable.com for the supplementary manual that gives instruction for more advanced procedures.
ADDITIONAL SAFETY RULES

BACKGROUND INFORMATION

4