Half-Pins Vs. Half-Tails; Tearout Reduction; Aligning The Templates - Porter Cable 4210 Manuel D'instructions

Table des Matières

Les langues disponibles

HALF-PINS VS. HALF-TAILS

Traditionally, dovetails have half-pins cut on both ends (Fig. G1). Half-tails will be just as strong, but will not be as

attractive (Fig. G2). If your joints are half-tails and you want half-pins, move the vertical board 1/2" either left or right,

then move the horizontal board accordingly. The procedure is the same with the 4215 Miniature template, except

that you move the boards 1/4".

Tearout is unwanted splintering of the wood fibers that occurs when a router bit enters, exits, or skims the edge

of wood and is common to all dovetail jigs. Tearout cannot be eliminated, but it can be reduced by the insertion of

additional scrap wood against the workpiece.

For proper operation, you must align the templates correctly from front to back. The 4200 series jigs have patented

alignment lines to help you align the templates without measuring. Some templates have one line (Fig. H1) while

others have several lines to produce multiple types of joints (Fig. H2). Porter-Cable has scribed icons on the

templates to indicate which lines go with which joints.

Adjust the templates front-to-back until the alignment line is directly over the point where the horizontal board and

the vertical board meet.

NOTE: To be accurate, lean over the template and look straight down to align the lines (Fig. H3).

For the joint to be produced correctly, loosen the knobs on both sides of the template, align the lines, hold the

template flat with one hand, and tighten the knobs with the other (Fig. H4).

NOTE: To help align both ends of the template when you are using a narrow workpiece, mount an additional piece

of wood (of the same thickness) on the far right (A) Fig. H5.

Table des Matières

4212 4216