Sliding Dovetails; Dado Board - Porter Cable 4210 Manuel D'instructions

Step 5 -
Clamp the second workpiece (A) Fig. S11 in the lower clamp (vertical mounting position) on the right side
of the jig flush against both the template (B) and against the right offset guide (C) with the outside surface
facing away from the jig.
Step 6 -
If the first and second workpieces are of different thicknesses, reset the router bit depth using the "tails/
box" bit depth guide.
Step 7 -
Rout between the fingers of the jig with the templet guide against the left side of the fingers, both in and
out. This light pressure toward the left will help to prevent loose joints (Fig. S12).
Step 8 -
Remove the second workpiece and assemble the joint (Fig. S13)
NOTE:
The fit (tightness) of the box joint cannot be adjusted.

SLIDING DOVETAILS

Sliding dovetails are used primarily in the construction of cabinets, entertainment centers and shelving. The 4200
series jigs have three preset depths for dadoes ( 1/4", 3/8" and 1/2"), but you can manually set your router bit depth
to any setting.
NOTE:
Be certain that the router bit will not cut into the base or offset guides during this cut.Everything is provided
for this cut in both the 4210 and 4212 jigs.
ITEMS NEEDED
Dado Template
●
17/32", 7° Dovetail Bit 43776PC
●
3/4" O.D. Template Guide, 42040
●
Template Guide Lock Nut, 42239
●
CUTTING THE DADO BOARD
Step 1 -
Mark the centerline (A) Fig. T1 of the dado location on the workpiece.
Step 2 -
Make two marks 3/8" from the centerline of the dado (B) Fig. T1.
Step 3 -
Insert the workpiece (A) Fig. T2 in the upper clamp (horizontal clamping position) and place the dado
template (B) on the jig with the dado side facing you. Adjust the template so that the lines that you drew
in STEP 2 (C) are aligned exactly with the edges of the slot.
A
S11
B
T1
S12
C
B
24
S13
A
T2