Clamps; Template Mounting - Porter Cable 4210 Manuel D'instructions

CLAMPS

The 4200 series jigs are equipped with two cam-action clamps (A) Fig. C1 with knobs (B) to
adjust for workpiece thickness, and levers (C) for quick clamping and releasing of workpieces.
NOTE: Use a scrap board (A) Fig. C2 to prevent misalignment (A) Fig. C3.
A
B
A
C1

TEMPLATE MOUNTING

You can mount the templates in two positions on the jig(s) which allows the production of multiple types of joints
with each template. To reverse a template, loosen the template knobs (C) Fig. D1, remove the template (B) from the
base, rotate it 180 degrees horizontally, replace it on the base, and tighten the template knobs.
NOTE: Secure the templates by inserting the template brackets (A) Fig. D2 between the large template knobs (B)
Fig. D2 and the brass adjustment knobs (C). You can then make front-to-back adjustments by loosening the large
template knobs (B) and rotating the brass adjustment knobs (C).
C
C
A
C2
ROTATE
D1
10 10
A
A
C
C3
B
D2