Modes Of Operation - Dometic MCS5 Notice D'utilisation

_BA_MCS.book Seite 9 Donnerstag, 2. April 2009 9:56 09
MCS5, MCS15
Set Temperature
Press the Up or Down button (fig. 1 3 and 4, page 2) to set the desired
room temperature.
The set point can be viewed by momentarily pressing and releasing the
Up or Down button.
Fan Speed
Fan-speed operation is automatic, allowing fan speed to decrease as the set
point temperature is approached in the Cool Mode. The fan operates at low
speed when set point is satisfied.
Use the Fan button (fig. 1 2, page 2) to select manual fan speeds.
You can program the fan to run only when cooling or heating is required. Nor-
mally the automatic fan-speed operation is reversed in the Heating Mode,
however, the fan can be programmed to operate the same as in the Cooling
Mode.
Memory
The control's nonvolatile memory requires no batteries or backup power.
When power is lost, the operating parameters are retained indefinitely. When
power is restored, the control resumes operating as last programmed.
7.3

Modes of Operation

Off Mode
When the Marine Climate System is in the Off Mode, all control outputs are
turned off. Program parameters and user settings are saved in nonvolatile
memory.
On Mode
When the Marine Climate System is in the On Mode, power is supplied to the
appropriate outputs and the display indicates the current state of operation.
The operating and program parameters resume based on those stored the
last time the unit was operating.
Cool Mode
When Cool Mode is selected, the Cool Mode LED is lit and the cooling
systems are operated as required. When the temperature drops below the
set point, the system will not automatically switch to the Heat Mode.
Operating
9