Dometic MCS5 Notice D'utilisation page 16

_BA_MCS.book Seite 16 Donnerstag, 2. April 2009 9:56 09
Programming
8.3 Saving New Program Parameters
Note
I
Factory defaults shown in the chapter "Programmable Parameters
Table" on page 17 may be reset manually (see chapter "Restore
Memorized Default Settings" on page 17).
Simultaneously press the Up and Down Buttons to save the new program
parameters.
This will set the new program defaults.
8.4 Exiting the Program Mode
There are two methods to exit the Program Mode.
Press the Power Button
The Marine Climate System will return to the Off Mode.
... or
Do not press any buttons and do not attempt any program changes for
one minute.
The Marine Climate System will exit the Program Mode.
8.5 Software Identification
The software version of the Marine Climate System is identified for one sec-
ond prior to the exit from the Program Mode. The software identification
number, e.g. ("A12") will appear in the display for one second, then the Ma-
rine Climate System will return to the Off Mode.
Note
I
Should there be any reason to contact Dometic about the system
or programming the Marine Climate System be sure to have the
software identification number and air conditioning unit serial
number available. The serial number may be found on the type-
plate.
16
MCS5, MCS15