Troubleshooting Guide - Hatco Toast Qwik TQ-10 Série Manuel D'installation Et D'utilisation

TROUBLESHOOTING GUIDE

WARNING
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
Symptom
Toast too light.
Toast too dark.
Unit takes too long to toast. The first few batches can take longer
Unit toasts on one side only. Toaster is a "buns" only model. (model
Toaster trips the circuit
breaker or GFCI.
Toaster conveyor doesn't
move.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please
contact the nearest authorized Hatco Service agency or Hatco
for assistance. To locate the nearest Service agency, log onto
the Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service
Team at:
Telephone: 800-558-0607 or 414-671-6350
e-mail: partsandservice@hatcocorp.com
Fax: 800-690-2966 or 414-671-3976
Probable Cause
COLOR CONTROL knob set on a light
setting.
Supply voltage to unit is low.
COLOR CONTROL knob set on a dark
setting.
Supply voltage to unit is high.
because the toaster needs time to heat up
when initially turned on.
Supply voltage to unit is low.
contains Ba in model name.)
BOTTOm HEaT or TOP HEaT Control set
too low.
Heating element defective.
Circuit breaker is not sized properly for the
toaster.
Wiring fault inside toaster.
Bread slices or buns jammed in conveyor
track.
ELECTRIC SHOCK HAzARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, setup, or maintenance.
Turn COLOR CONTROL knob to a darker setting.
Verify the supply voltage to the toaster matches the
unit specifications.
Turn COLOR CONTROL knob to a lighter setting.
Verify the supply voltage to the toaster matches the
unit specifications.
allow toaster to heat up to full operating temperature
before inserting bread product (approximately 15–20
minutes).
Verify the supply voltage to the toaster matches the
unit specifications.
Unit is designed to perform in this way.
Turn the BOTTOm or TOP HEaT control to a higher
setting.
Visually check the heating element inside the toaster
during operation. The heating element should glow
red. If the element does not glow, Contact authorized
Service agent or Hatco for assistance.
Check circuit breaker for proper sizing.
Contact authorized Service agent or Hatco for
assistance.
Turn off unit, wait for unit to cool, and remove bread
product jamming the conveyor.
16
English
WARNING
Corrective Action
Form No. TQ2m-0414