Troubleshooting Guide; Options And Accessories - Hatco Toast-Qwik TQ3-10 Série Manuel D'installation Et D'utilisation

English
WARNING
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
Symptom
Toast too light.
Toast too dark.
Unit not working at all.
Unit toasts on one side only.
Toaster trips the circuit breaker
or GFCI.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco
for assistance. To locate the nearest Service Agency, log onto the Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service Team at:
Telephone: 800-558-0607 or 414-671-6350
Security Cover
The lockable security cover flips up and down to limit access
to the control panel.
1. Remove the crumb tray.
2. Remove the two front screws on the platform above the
controls.
3. Position the security cover over the control panel, aligning
the mounting holes on the security cover with the screw
holes on the platform.
4. Reinstall the two screws through the security cover and
into the platform. Tighten securely.
5. Reinstall the crumb tray.
Form No. TQ310M-0118
Probable Cause
Color Control knob set on a light setting.
Unit not warmed up. The toaster needs time to
heat up when initially turned on.
Supply voltage to unit is low.
Color Control knob set on a dark setting.
Supply voltage to unit is high.
Unit not plugged in.
High Limit switch tripped and Warning Light
illuminated.
High Limit
Reset
Button
The toaster is in BUNS mode (one-sided
toasting).
Heating element defective.
Circuit breaker is not sized properly for the toaster. Check circuit breaker for proper sizing.
Wiring fault inside toaster.
e-mail: support@hatcocorp.com

TROUBLESHOOTING GUIDE

ELECTRIC SHOCK HAZARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, adjustments, maintenance, or
attempting to clear a jam.
Turn Color Control knob to a darker setting.
Allow approximately 15 to 20 minutes for the unit to
warm up.
Verify the supply voltage to the toaster matches the unit
specifications.
Turn color control knob to a lighter setting.
Verify the supply voltage to the toaster matches the unit
specifications.
Plug unit into proper power supply.
Check for the following:
1. Make sure hot air from other sources is directed away
from the front of the unit.
2. Make sure the fan filter is clean.
Press the High Limit Reset Button on rear of unit. If
problem continues, contact Authorized Service Agent or
Hatco for assistance.
Press the "Bread"
toasting).
If the element does not glow, contact Authorized Service
Agent or Hatco for assistance.
Contact Authorized Service Agent or Hatco for assistance.

OPTIONS AND ACCESSORIES

Installing the Security Cover
9
WARNING
Corrective Action
( )
key for Bread mode (two-sided