Power Save Mode With Indicator Light; Adjusting The Toast Feed Ramp - Hatco Toast Qwik TQ-10 Série Manuel D'installation Et D'utilisation

OPERATION

Power Save Mode with Indicator Light

all TQ-400, -800, -1200, and -1800 series toasters have a built-
in Power Save mode with Indicator light feature. This feature
reduces power to the heating elements by 50 percent. During
Power Save mode the indicator light on the POWER SaVE
button will flash.
To activate Power Save mode:
1. Press the POWER SaVE button until the indicator light
flashes.
To exit Power Save mode:
1. Press the POWER SaVE button or turn any knob until the
indicator light stops flashing.
NOTE: Allow a minimum of 2–3 minutes before toasting. Unit is
back up to full power within 10 minutes.
ColorGuard System
all TQ-400, -800, -1200, and -1800 series toasters use
a patented ColorGuard Sensing System that monitors
and automatically adjust conveyor speed during high
usage periods to assure toast color uniformity.
NOTE: The ColorGuard Sensing System is inoperable for
approximately ten minutes after any heat adjustments
are made.

Adjusting the Toast Feed Ramp

The toast feed ramp is installed at the factory and can be used
in two positions.
Automatic Feed Position
For automatic feed, the toast feed ramp should be in an upright
position. Bread products enter the toaster by placing them on
the feed ramp and releasing.
Manual Feed Position
For manual feed, the toast feed ramp should be in a horizontal
position on top of the toaster. Bread products are manually
loaded by placing directly on the conveyor belt.
Automatic Feed
Position
14
English
Manual Feed
Position
Toast Feed Ramp
Form No. TQ2m-0414