Cleaning Your Teeth Using The Brush Head - Nevadent NSZB 3.7 C4 Mode D'emploi

Masquer les pouces Voir aussi pour NSZB 3.7 C4:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36

Cleaning your teeth using the brush head

NOTE
Due to the unfamiliar sensation of the toothbrush, there may be some initial gum
bleeding. This is normal. If this continues for more than two weeks, you should
consult your dentist.
Place the brush head 1 on the handset.
Moisten the brush under flowing water.
Put a little toothpaste onto the wet brush.
NOTE
To avoid splashes, do not switch on the appliance until the brush is in your mouth.
Use the On/Off button 3 to select the desired programme.
NOTE
This toothbrush has a 30-second interval timer, so that all four jaw quadrants can
be cleaned evenly.
Divide your mouth into four parts (quadrants): upper right, upper left, lower right and
lower left.
Begin in one quadrant:
Start with the brush head 1 on your gums, and move the brush upwards/down-
wards from the gums to the crown of the tooth. Continue in this manner on both the
inside and the outside of the tooth. Start again on the gums for each individual tooth.
Do not forget the back surfaces of the rear molars. To clean the chewing surfaces,
guide the brush over the chewing surfaces with a little pressure.
After 30 seconds, the toothbrush stops briefly to signal that you should start cleaning
the next quadrant. Clean all jaw quadrants using the same technique.
After two minutes, the toothbrush stops. This means that you have complied with the
dental recommendation of 2 minutes cleaning.
NSZB 3.7 C4
GB │ IE
 9

Publicité

Table des Matières
loading

Table des Matières