Cleaning And Care - Nevadent NAZ 2.4 A1 Mode D'emploi

6) Start in one quadrant:
GB
Start with the brush head 2 on your gums,
IE
and move the brush upwards/downwards
from the gums to the crown of the tooth.
Proceed in this manner on both the inside and
the outside of the tooth. Start again at the gums
for each individual tooth.
Do not forget to brush the back of the rear
molars.
To clean the chewing surfaces, guide the
rotating brush head over the chewing sur-
faces with a little pressure.
7) After 30 seconds, the toothbrush stops briefl y
to signal that you should start cleaning the
next quadrant. Clean each jaw quadrant
using the same technique.
8) After two minutes the toothbrush stops its
operation briefl y 4 times. This informs you that
you have complied with the dental recommen-
dation of two minutes cleaning.
9) Press the on/off switch 3 repeatedly until the
toothbrush stops.
10) Then take the toothbrush out of your mouth.
11) After use, rinse the brush head 2 thoroughly
under running water.
12) Remove the brush head 2 from the handset.
To clean the drive shaft and the handset,
allow a little water to fl ow over them. Hold
the handset so that the drive shaft is pointing
downwards.
NOTE
Regularly massage your gums. This promotes
blood circulation and helps to keep them healthy.
Set the mode to "Pulse" and guide the moistened
brush over your gums with a light pressure.
6

Cleaning and care

DANGER – ELECTRIC SHOCK!
Always remove the plug of the charger 8
►
from the power socket before cleaning the
appliance! Risk of electric shock!
Never submerge the handle or the
charger 8 in water or other liquids.
NOTE
Never open the housing of the charger 8 or
the toothbrush! They cannot be resealed in a
water-tight manner.
1) Clean the charger 8 only with a soft, lightly
moistened cloth. Do not use detergents or sol-
vents. They can damage the plastic surfaces.
2) Remove the brush head 2 from the handset.
After use, clean the brush heads 2 thoroughly
under running water.
We recommend cleaning the brush heads 2
in a standard commercial denture cleaning
fl uid every 2 - 4 weeks. A new brush head 2
should be fi tted after about 3 months, and the
brush head must always be replaced when
the bristles start to bend outwards.
3) To clean the drive shaft and the handset,
allow a little water to fl ow over them. Hold
the handset so that the drive shaft is pointing
downwards.
NAZ 2.4 A1