Handling And Use; Fitting The Cleaning Attachment - Nevadent NZR 1.5 A1 Mode D'emploi

3) Push the housing 7 back onto the hand set 4 until it sits
fi rmly in place and the gap is fully closed. The anti-slip
dimples on the housing 7 must be on the same side as
the anti-slip dimples on the hand set 4. The writing on
the housing 7 must be on the same side as the operat-
ing button 5.
NOTE
► If the eff ectiveness of the cleaning starts to decrease, the
battery 6 needs to be replaced.

Handling and use

This section provides important information about proper hand-
ling and operation of the appliance.

Fitting the cleaning attachment

1) Remove the appliance head 1 by turning it slightly so
that the dot on the appliance head 1 is aligned with the
head 1 upwards and off .
2) Push the attachment fi tting 3 into the hole of one of the
cleaning attachments 2 in the storage box 8. You will
feel a slight click.
3) Pull the hand set 4 away from the storage box 8. The
cleaning attachment 2 comes out of the storage box 8.
4) Check that the cleaning attachment 2 is fi rmly attached
to the attachment fi tting 3. If necessary, push the clean-
ing attachment 2 onto the attachment fi tting 3 with
slightly more force.
5) Replacing the appliance head 1: guide the fi tted clean-
ing attachment 2 through the hole in the appliance
head 1. The dot on the appliance head 1 must align
with the
dot is lined up with the
NZR 1.5 A1
1) Carefully pull the housing 7 off the hand set 4
and place it to one side.
2) Insert the battery 6. Pay attention to the polarity
markings given in the battery compartment.
symbol on the hand set 4. Then pull the appliance
symbol. Turn the appliance head 1 until the
symbol.
GB │ IE │
7 ■