Arneg UCA Manuel D'installation Et De Service page 63

Technical Manual
Use and Maintenance of Condensing Units
On the pallet of the units are applied to the structure of the units to indicate the correct position of the forks to ensure
stability of the load, as shown below.
Fig. 4: Positions for hoisting
If a crane is used, instead of a forklift, a hoisting fork of adequate capacity should be used or the load should be
strapped at the hoisting points marked with the yellow stickers mentioned above.
The strapping should be of a type that will not create transverse stress on the machine structure; the strappings should
not damage the parts of the unit.
NOTE: Do not use hoisting and strapping points other than those indicated on the machine.
During storage and shipment, make sure the unit rests on the ground or on the floor of the means of transportation, only
with the pallet provided for that purpose.
CODE: 05050532 Edition 02 15-04-2003
24
05050532 03 11/02/2010