Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
tibial control strap. Accurate planar setting will help to ensure
optimal brace suspension.
warning: If brace causes discomfort or irritation, discontinue use
immediately and contact your health care provider.
BRACE MAINTENANCE
The CTi OTS brace is designed for minimum maintenance and care.
Follow these easy maintenance steps to keep your brace in good
condition.
Cleaning
• Liners, straps and pads may be removed for cleaning
• Do not machine wash
• Do not place in dryer
• Hand-wash using mild non-detergent soap 30 °C
• Rinse thoroughly
• Air-dry
If migration occurs, clean silicone liners with an alcohol wipe or
damp cloth. If brace is used in salt water or chlorinated water, rinse
well and air dry.
Hinge maintenance
• Do not disassemble the hinge
• Check regularly for foreign materials in hinge (i. e. dirt or grass)
• Carefully clean dirt from hinge using water or compressed air
• Lubricate with silicone spray or dry graphite if needed

ACCESSORIES

The following accessories are available for your CTi OTS brace at an
additional charge.
To order call your Össur Customer Service Department.
• Patella cup – Knee cap protection, especially for motocross,
mountain biking or work that requires kneeling
• Motorcross kit – Includes patella cup, gear guards, under sleeve
and stickers
• Flexion stop kit - Stops can be set from 0°–90°
• Anti migration wrap
• Liner kit
• Strap kit
• D-ring kit
• Subshell kit
• PCL Kit - to counteract against posterior subluxation of the tibia
SETTING UP THE D-RING
The field-serviceable d-rings can be changed from internal to
external d-rings or replaced if a d-ring is broken.
1. While holding the d-ring firmly against the frame, remove the
screw (Figure 6).
2. Remove the d-ring system from the frame (Figure 7).
3. Replace the broken d-ring/inserts with new d-ring/inserts (if
applicable)(Figure 8).
4. Snap the female insert into the d-ring.
5. Place the d-ring/female insert assembly into the bronze bearing
in the frame with the washer under the d-ring (internal or
U 0337_CTi OTS.indd 7
7
26.7.2013 20:55:19

Publicité

Table des Matières
loading

Table des Matières